Manual

SETTING THE STITCH LENGTH

The length of the stitch is regulated by the dial, 11, shown in Fig. 17. Near 0 is the

shortest stitch and 6 is the longest, but the dial may be set at any spot between markings

for a variety of lengths. Turn the dial to the right to lengthen and to the left to shorten the

stitch. The number of the stitch length you choose should appear above the center line on

the reverse button R.

STITCH LENGTH CHART ( Approximate)

Figures on indicator 0 12 3 4

Number of stitches per inch No Feeding 30 15 10 8

SEWING IN REVERSE

When you wish to sew backward to tie the threads at the beginning or end of a seam,

press in the button R, Fig. 17, as far as it will go. The machine will sew backward as long

as the button is held in.

ADJUSTING THE TENSIONS

Always adjust the upper tension with the presser foot

down, as the tension is automatically released when it is rais

ed. To increase the tension on the upper thread, turn dial

(Fig. 18) to the right, or clockwise. To decrease, turn to the

left. The higher the number on the dial, the tighter the ten

sion. Before adjusting lower tension be sure that the machine

is threaded properly. When necessary to change the bobbin

tension, turn small screw (Fig. 19 ) on side of the bobbin Tvntlou fl

case clockwise to tighten, coimterclockwise to loosen. • _ .

Fig. 18