Instruction Manual

■ f;

lOv* •

Before oiling the tipper part of the sewing unit at points indicated by arrows in Fig. 22 turn

hand wheel toward you until the take-up lever is at its lowest point.

Avoid over-oiling-only a drop is needed at each point.

To oil parts under the bed of the machine, tip the unit back on its hinges and apply a drop

of oil at each point indicated in Fig. 23.

CLEANING AND OILING THE SHUTTLE

(See Fig. 24 and 25)

The stitch forming mechanism occasionally becomes

clogged with loose threads and lint. This will interfere

with the efficient operation of the machine. Cleaning

and removal of the lint will safeguard the performance.

To remove the shuttle assembly, proceed as follows;

1. Turn the balance wheel until the needle reaches its

highest position. Tilt head back on its hinges

2. Remove bobbin case (A)' Fig. 24.

3. Turn the two shuttle race cover clamps (B) downward

and remove the shuttle race cover (D) and shuttle

body (D).

Fig. 24