Instruction Manual

r
fii 3
*11
ii}^
?11"
if ’
'i ^
i;
*%i ^
>i 3
K
17
shuttle race
outer edge
as
4. Clean the shuttle race, the shuttle, and
cover by removing all threads, lint etc.
5. Apply a drop of oil with finger tip to
of shuttle.
When the cleaning has been completed, proceed
follows to replace the shuttle assembly;
Turn the balance wheel until the needle reaches its
highesj: position.
Place shuttle body, (D), in race against shuttle driver.
Replace shuttle race cover, iC), over hinge pin at lower edge and lock into position with
s u e race cover clamps, (B) making certain the clamps have been snapped securely into
4.
5.
1.
2.
3.
4.
5.
position.
Put bobbin into bobbin case.
Put the bobbin case into the shuttle race, fitting tongue into notch E of race cover.
ACCESSORIES
Plastic Oiler
(Sealed and filled)
Package of Needles (5:
Large Screw Driver
Small screw Driver
Felt washers (2)
(For spool pins)
Bobbins (3)
o
5
o