User guide

5. INSERTING AND REMOVING THE BOBBIN CASE
1. Raise the presser bar by lifting the presser bar lifter.
2. Raise the needle bar to its highest position by turning the balance wheel towards you.
3. Pull out slide plate (Fig. 6). . . ^ ^
4. After threading the bobbin case, hold its latch (Fig. 7) between the thumb and forefinger of the left hand, with its
position finger opposite the notch at the top of the shuttle race and replace it on the center stud of the shuttle
(Fig >).
5. Theh release the latch and press the bobbin case back until the latch catches the groove near the end of the stud.
6. Allow the end at the thread to hang free.
7. Push back slide plate. To remove the bobbin case do all the above in reverse order.