Manual

Adjusting Lower Tension
To test bobbin tension, hang and
shake bobbin case as shown.
At proper tension bobbin case
will gradually drop a small
amount.
To adjust tension, turn adjusting
screw with small screwdriver.
Raise needle in the highest
position.
Leave end of thread of about 10
cm (4") from bobbin case.
Take hold of latch and push
bobbin case into hook.
Release latch when bobbin case
is fully inserted.
Drop Feed Lever
The lever is on right side of hook.
To lower feed dog, move lever
down to Si position.
This position is for button sewing,
darning and embroidery.
For normal sewing, move lever
up to ^position.
-12-