Instruction Manual
Table Of Contents
- TABLE OF CONTENTS
- tNTRODUCTtON
- SECTION I
- KNOW YOUR MACHINE - MODEL 2000 ATS
- SUPERLOCK SET UP & MAINTENANCE
- HINTS FOR SUCCESSFUL STITCHING
- Thread Selection
- NEEDLE REPLACEMENT
- NEEDLES, THREAD & FABRIC CHART
- SECTION II - THREADING & TENSION
- )
- NEEDLE THREADER
- HELPFUL HINTS - CHANGING THREAD
- TESTING STITCH
- THREAD TENSIONS
- ADJUSTING THREAD TENSION
- SUPERLOCK SEAMS & SEAM FINISH
- ADJUSTING STITCH LENGTH
- ADJUSTING CUTTING WIDTH & BALANCE OF STITCH
- ADJUSTING CUTTING WIDTH
- SECURING BEGINNING & END OF SEAM
- OUTSIDE CORNERS
- INSIDE CORNERS
- CORDED OVERLOOK
- RIBBING
- CASING OR HEM FOLD
ADJUSTING STITCH LENGTH
Turn the stitch length dial (located on the right side of your Superlock) until the
required length is at the guideline. The higher the number, the longer the stitch.
With the dial you can adjust the stitch length from R for rolled edge to 5mm.
Stitch Length Sample
Machine Settings
Stitch length: 1 - 5 (see illustration)
Stitch width: 6
Fabric Medium weight woven
Tension Settings
Normal
LN
-4-
RN -4-
UL -4-
LL - 4-
Serge
•Fold fabric in half.
•Set stitch length to 5mm.
•Stitch along edge stopping every inch and
decreasing stitch length to 4, then 3, etc.
24