Instruction Manual
Table Of Contents
- TABLE OF CONTENTS
- tNTRODUCTtON
- SECTION I
- KNOW YOUR MACHINE - MODEL 2000 ATS
- SUPERLOCK SET UP & MAINTENANCE
- HINTS FOR SUCCESSFUL STITCHING
- Thread Selection
- NEEDLE REPLACEMENT
- NEEDLES, THREAD & FABRIC CHART
- SECTION II - THREADING & TENSION
- )
- NEEDLE THREADER
- HELPFUL HINTS - CHANGING THREAD
- TESTING STITCH
- THREAD TENSIONS
- ADJUSTING THREAD TENSION
- SUPERLOCK SEAMS & SEAM FINISH
- ADJUSTING STITCH LENGTH
- ADJUSTING CUTTING WIDTH & BALANCE OF STITCH
- ADJUSTING CUTTING WIDTH
- SECURING BEGINNING & END OF SEAM
- OUTSIDE CORNERS
- INSIDE CORNERS
- CORDED OVERLOOK
- RIBBING
- CASING OR HEM FOLD
OUTSIDE CORNERS
You can stitch neat outside corners with little practice on your Superlock.
Machine Settings
Stitch Length: 2.5 •
Stitch Width: 6
3.0
Fabric
Medium weight woven
Tension Settings
Normal
(LN) -4-
(RN) -4-
(UL) -4-
(LL) -4-
Serge (Sew along edge of fabric; do not trim.)
•Sew along one side of fabric to the end.
•Raise the needles and presser foot.
•Gently slide the threads off the stitch
finger of the needle plate by pulling fabric toward back of Superlock.
•Grasp the fabric gently and turn the corner.
•Realign the edge of the fabric and put the cut edge of the fabric against the cutter.
•Pull up slack in threads.
•Lower presser foot.
•Serge the edge. Repeat for the remaining corners.
28