User Manual

Connecting to a DC Source

The following procedure describes how to connect the scanner to an AC

Outlet.

1. Verify that the On/Off switch on the scanner front panel is in the

OFF (down) position.

2. Connect a DC power supply to the DC receptacle on the scanner

front panel. The DC power supply must provide between 8-35 VDC

at 2 AMPs and must have an AMP connector, with part number

1-480698-0, and socket terminations.

3. Set the On/Off switch to the ON (up) position. The Power ON LED

light will illuminate.

U519 FCC rewrite 2-22-01.p65 2/22/2001, 2:43 PM14