User Manual

18
Aligning the Antenna
After verifying that the scanner is operating properly, use the following
procedure to align the antenna(s). Aligning the antenna(s) ensures
optimal performance.
1. Connect the scanner to COM1 or COM2 and turn the power on.
2. Run the application “Series 5 Test Tool” in the “Series 5 Tools”
folder in the start menu.
3. From the mode menu, choose “Antenna Alignment”.
4. Select the antenna you wish to align with the available antenna
buttons. Press the “Go” button.
5. Move a tag into the “scanning area”, the point where you intend
to scan.
6. Adjust the antenna until the application indicates it detects a tag.
You can find the complete scanning field by moving the tag
around. When the application detects a tag, the window will flash
with the message “Label Found”. Press the “GO” button again to
stop the alignment test.
7. If you have other antennas connected, you can select the different
antennas by using the antenna buttons on the top of the window.
This completes the scanner installation procedure.
U519 Manual.p65 10/27/2000, 4:35 PM18