User Manual

20
Reading Information from your Dura-labels
Once you have installed your tags, and have set-up your scanner sys-
tem, you are ready to begin.
1. Run the “Series 5 Demo” application in the “Series 5 Tools” folder in
the start menu.
2. The connect dialog box will appear, set COM Port to the port where
the scanner is connected, Baud Rate to the highest value supported
by your computer and cable length. Set “# of Antenna” to the
appropriate value then click the “Connect” button.
3. After a few seconds, the main SCS Demo dialog will come up. The
scanner is in List-ID mode. As you move a tag into the field in front
of the antenna, you will see the ID of that label displayed under
Label ID.
4. Try moving additional tags in front of an antenna. You can also
reset the display with the Clear button.
5. Double click on the ID of a tag to bring up detailed information
about that tag. This will bring up a tag dialog where you can see the
data in each of the memory locations of the label. Additional usage
of this dialog is described in the following section.
U519 Manual.p65 10/27/2000, 4:35 PM20