Installation Guide

Bathtubs:Rough-InWasteDrain

The copper bathtub rough-in kit not only makes installation easier,

butitsavestimeandmoney.Designedtoworkspecicallywith

Sinkologycopperbathtubs,andisprotectedbyaLifetimeWarranty.

1. Final waste drain and waterline rough-in’s should be completed

andooringshouldbenished.Ensurebathtubisproperly

supported and level.

2. Double check bathtub faucet installation requirements before

nalbathtubinstallation.

3. Apply thread sealant or plumbers tape to any threaded

connections that do not have rubber gaskets.

4. Applyplumbersputtytoundersideofdrainangeandthread

through the bathtub and into drain pipe.

5. Ensurewastedrainandoverowissecurelyconnectedto

bathtub.

6. Place tub back into desired location and verify that bathtub is

level. If using recommended rough-in kit (#ITD35), the tub will

needtobeliftedapproximately8”beforeloweringintonal

position.

7. Finish installation by running a bead of silicone adhesive

around the base of copper freestanding bathtub where

applicable to create a watertight seal.

8. Allow sealants and adhesive to thoroughly dry before

llingbathtubwithwater.Consultsealantandadhesive

manufacturers for dry times, as they may vary.

Important

Sinkology copper bathtubs are handmade so variations in dimensions can

occur.Werecommendperformingrough-inprocedureswiththebathtub

on site to ensure the correct installation.

PRO

DIY