Installation Guide

Step 1. Flip sink upside down and trace outside edge onto craft paper or card-
board. Add second line that is 1/2” inside that line. Cut out the center of
the traced template using the second line.
Step 2. Position the template at on the countertop to align with cabinet and
plumbing connections. Mark opening on countertop. Drill a 1/2” hole on
the inside of the scribed line to start cutout, then use a jigsaw to cut the
countertop.
Step 3. Position the sink in the hole and check for gaps around the rim. Eliminate
gaps by gently tapping the rim with a rubber mallet.
Step 4. Attach drain assembly
to sink.
Step 5. Apply silicone to the bottom rim of the sink. Position the sink in the
cutout, and use weight in the basin to hold the sink in place.
Step 6. Clean excess silicone.
Apply polyurethane to
seal the gap between
the sink and countertop.
Mount faucet.
Step 7. Treat copper sinks with
Sinkology Copper Armor
for maximum protection
(apply based on
directions on bottle).
Bag
(Weight)
Spray Foam
Silicone
BATH – DROP-IN INSTALLATION
Plumbers putty (or Silicone)