Installation Guide

Step 1. Flip sink upside down and trace outside edge, noting where the rim is
located, on craft paper or cardboard. Add second line that is inside that
line at the desired offset. Cut out the center of the traced template
using the second line.
Step 2. Place the template on to the countertop, trace the edge with a pencil,
and cut the hole into the countertop.
Step 3. Assemble waste tting
to basin, and use silicone
to seal between waste
tting and the inside of
the basin.
Step 4. Mount sink
to countertop.
Step 5. Clean excess silicone and mount faucet.
Step 6. Treat copper sinks with Sinkology Copper Armor for maximum
protection (apply based on directions on bottle).
BATH – UNDER-MOUNT INSTALLATION
Bracket
(only bracket included)
Washer
Solid Surface Countertop
Wingnut
Brass Insert
Screw
Bowl
Plumbers putty (or Silicone)