Instructions / Assembly

ENGLISH
ENGLISH
2
FAUCET INSTALLATION
3
PRELIMINARY STEPS
4
5
6
Thank you for purchasing this Pster product. All Pster products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Pster
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3 TOOLS RECOMMENDED
• Plumber's putty • Philips head screwdriver • Pliers
• Adjustable wrench • Flashlight • Cloth
Your installation may require new supply lines and/or shut-off valves or other additional
tools.
4 VALVE BODY PREPARATION
First, remove Clip (4A) then remove Inlet Connector (4B) from Valve Bodies (4C) and
save. Next, remove Locknut (4D), and Square Washer (4E) from Valve Bodies (4C)
and save.
6 INSTALLING PUTTY RINGS
Following manufacturer’s recommendations on use, place a bead of plumber’s putty
in the bottom groove along the outer edge of Putty Rings (6A). Place Putty Rings (6A)
over sink holes (6B).
5 HANDLE BODY ATTACHMENT
Slide the Handle Connectors (5A) onto the Spout Bridge (5B). Push the Handle
Connectors (5A) all the way until completely seated. Be careful not to damage O-Rings
(5C). Be sure that the Buttons (5D) are facing the rear, as shown.
2
LEFT
RIGHT
4A
4B
4D
4E
4C
5A
5A
5B
5D
5B
5B
5C
6A
6A
6A
6B
6B
6B
1
1
/
4
” [32 mm] MIN.
1
1
/
2
” [38 mm] MAX .
DIA. HOLES
3 PLACES