Instructions / Assembly

ENGLISH

7 FAUCET BODY INSTALLATION

Insert the faucet Pull-out Hose (7A) through the center hole of the sink. Insert Valve

Shanks (7B) through the end holes of the sink.

8 SECURING FAUCET BODY

From underneath sink, place Square Washers (8A) onto Spout Shank (8B) and Valve

Shanks (8C). Tighten Locknuts (8D) by using Installation Tool (8E). For better leverage,

use a Screwdriver (8F), insert it through Hole (8G) and tighten the Locknuts (8D) until

Faucet Body (8H) is rmly secured to sink.

9 HOSE CONNECTION TO VALVE BODY

Slide the End Connectors (9A) with arrow (9D) pointing up onto the Valve Bodies (9B).

Push the End Connectors (9A) all the way up until completely seated. Be careful not

to damage O-Rings (9C).

Reverse steps to remove Hose Connection.

10 WATER SUPPLY CONNECTIONS

First, thread Inlet Connectors (10A) into Water Supply Lines (10B). Then, insert Inlet

Connectors (10A) into Valve Bodies (10C). Hot water supply lines go into left inlet.

Cold water supply lines go into right inlet. (Supply lines not included). Please follow

manufacturer’s instructions when installing supply lines. Next, insert Clips (10D) into

Valve Body Holes (10E), to secure unit.

WARNING: Do not twist Inlet Connectors (10A) once installed!

Reverse steps to remove.

HOT

COLD

10A

10C

10B

10D

10E

10D