Operation Manual

GETTING READY
13．Press (Start/stop button) once.
When the foot controller is plugged in, press down on the foot controller.
1. Start/stop button
 The bobbin starts winding and "Winding bobbin thread..." is displayed on the LCD screen.
Note
 Do not get away from the machine while winding the bobbin. Make sure the bobbin thread is being
wound correctly. If the bobbin thread is wound incorrectly, press (Start/stop button) or operate the foot
controller immediately to stop the bobbin winding.
14．When the bobbin winding stops or becomes slow, press (Start/stop button) once to stop the
machine.
When the foot controller is plugged in, remove your foot from the foot controller.
 The bobbin winding will stop.
CAUTION
● Be sure to pull the thread tightly and wind it clockwise. If the thread is wound
counterclockwise, the thread
may wind around the bobbin winder shaft.
● Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using
the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the
bobbin or the bobbin thread starts to run out.
Wind five or six times.
A Caution
● When the bobbin winding stops or becomes slow, stop the machine. Otherwise, the sewing
machine may be damaged.
15．Cut the thread with scissors, slide the bobbin winder shaft to the left, and then remove the
bobbin from the shaft.
Memo
 If the bobbin winder shaft is set to the right side, the needle will not move. (Sewing is impossible.)
26/135 SINOJO OPTOELECTRONIC TECHNOLOGY