User Manual

Banana PI User Manual
www.sinovoip.com.cn www.banana-pi.com
15
CON2 P21 LCD0-D6 LVDS0-VPC PD6
CON2 P22 LCD0-CLK PD24
CON2 P23 LCD0-D7 LVDS0-VNC PD7
CON2 P24 GND
CON2 P25 LCD0-D8 LVDS0-VP3 PD8
CON2 P26 LCD0-D23 PD23
CON2 P27 LCD0-D9 LVDS0-VN3 PD9
CON2 P28 LCD0-D22 PD22
CON2 P29 LCD0-D10 PD10
CON2 P30 LCD0-D21 PD21
CON2 P31 LCD0-D11 PD11
CON2 P32 LCD0-D20 PD20
CON2 P33 LCD0-D12 PD12
CON2 P34 LCD0-D19 PD19
CON2 P35 LCD0-D13 PD13
CON2 P36 LCD0-D18 PD18
CON2 P37 LCD0-D14 PD14
CON2 P38 LCD0-D17 PD17
CON2 P39 LCD0-D15 PD15
CON2 P40 LCD0-D16 PD16
UART specification:
The jumper J11 is the UART interface. For developers of Banana Pi, this is an easy way to get the UART console
output to check the system status and log message.
Multiplex Function Select GPIO
J11 Pin Pin Name
Multi 1 Multi 2
J11 Pin1 TXD UART0-TX PB22
J11 Pin2 RXD UART0-RX PB23
The jumper J12 provides the power source including 3.3V and 5V. There is a pair of UART TX/RX signals
output here.
Multiplex Function Select GPIO
J12 Pin Pin Name
Multi 1 Multi 2
J12 Pin 1 5V
J12 Pin2 3.3V
J12 Pin3 NC IO-7 PH5
J12 Pin4 RXD UART7_RX PI21
J12 Pin5 NC IO-8 PH3
J12 Pin6 TXD UART7_TX PI20