Manualshelf

Manual

ManualsBrandsSioux Tools ManualsPower Tools1456HP
12345678910
1
Printed In U.S.A.
Form ZCE449
Date 10-97/A
Page 1 of 12
INSTRUCTIONS AND PARTS LIST FOR 1450HP, 1451HP, 1452HP, 1453HP, 1454HP,
1455HP, 1456HP DRILLS
(SERIAL “B”)
Read and understand "Safety Instructions For Air Tools" and these instructions before
operating this tool.
AIR SUPPLY
The efficiency of the tool is dependent on the proper supply of clean dry air at 90 psig (6.2 bar). The use of a line filter, pressure
regulator, and lubricator will insure maximum output and life of tools. Before connecting tool, blow out the air line to remove water
and dirt which may have accumulated.
HOSE AND HOSE CONNECTIONS
Supply hose should be not less than 3/8" (10mm) I.D. Extension hoses should be at least 1/2" (13mm) I.D. Use couplings and fittings
with at least 3/8" (10mm) I.D.
LUBRICATION
Use SIOUX No. 288 air motor oil. An airline lubricator, set to deliver 2 to 4 drops per minute, is recommended. If a lubricator is not
used, add .04 oz. (1.2cc, 12 to 15 drops) of oil into the air inlet twice daily.
Lubricate the gearing every 100 hours of operation with SIOUX No. 289A grease.
GENERAL OPERATION
This tool is equipped with a teasing throttle. By slightly depressing the trigger the chuck will rotate slowly. This is useful for
starting a drill bit without first spotting with a punch. The tool will run at maximum speed when the trigger is fully depressed.
If the gear case is removed or loosened, re-tighten to 35 ft-Ib.
*Sound Pressure *Sound Power *Vibration
Catalog No. dBA dBA m/s
2
1450HP 81.2 93.33 Less Than 2.5
1451HP 81.2 93.33 Less Than 2.5
1452HP 81.2 93.33 Less Than 2.5
1453HP 81.2 93.33 Less Than 2.5
1454HP 81.2 93.33 Less Than 2.5
1455HP 81.2 93.33 Less Than 2.5
1456HP 81.2 93.33 Less Than 2.5
*per PN8NTC1 *per PN8NTC1 *per ISO 8662
SOUND AND VIBRATION READINGS
June 1, 1997
Sioux City, Iowa, USA
R. V. Caskey
President
Sioux Tools Inc.
Date and place
of issues
Name and position
of issuer
Signature of issuer
DECLARATION OF CONFORMITY
We, Sioux Tools Inc., 2901 Floyd Boulevard, P.O. Box 507, Sioux City Iowa, 51102, USA, declare under our sole responsibility that the
products
1450HP, 1451HP, 1452HP, 1453HP, 1454HP, 1455HP, 1456HP
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
EN 792 (draft), EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.

Summary of content (12 pages)