'On/Off valve to exhaust the air from the¥fee hose before fitting, removing or adjusting the working attachment fitted to the tool. -Before using the tool make sure that a shut off device has been fitted to the supply line and the position 1 3 known and easily aaoeaaibia SO that the supply to the tool can be shut off in an emergency. Chech hose and fittings regularly f a wear.
20mm Belt Sander fief N o Part N o 1 67313 2 67314 1 Description Ref No 7 1 8 1 I 67316 , 67317 IValve Body, 1 Throttle Lever 36 I I 38 1 35 1 1 1 Shoe 1 67342 !Tension Arm I 67343 1 Stoooer Pin 1 67345 1 Cap Screw (2) ç 9 66540 Lever Pin 40 67347 Idle Pulley 67318 Deflector 41 67348 Ball Bearing (21 M 11 67319 Air Inlet 42 67349 Idle Shaft 12 67320 Motor Nut 43 67350 45 1 15 - 1 67622 1 Rear Plate 16 67323 Cylinder 17 67324 Rotor 18 6732
Dismantling & Assembly Disconnect loo) from air supply Lift cover(44). press down stoppef(28) 10 reduce tension on the abrasive belt and push on idle pulley(40) 10 remove belt. Remove capscrew(38)and washer(37) to remove shoe(32). Take out 2 off scfews(38) and 2 off washers(37) to removs tingaplate(39). Take out ide shaft screw(42) to release ide pulley assembly. "The ide pulley assembly may be dismantled by tapping out the bearings(41) from idle pulley(40) releasing cdlar(43).