Installation Guide

ManualsBrandsSir Faucet ManualsBathroom Sink FaucetsBrushed Nickel 2-Handle Widespread WaterSense Bathroom Sink Faucet with Drain

Model 706

Wide Spread Lavatory Faucet

Tools

Certifications & Information

Configuration

Installation Guide

Gather the necessary tools as shown to complete the installation of this faucet.

Connect to water supply lines with TWO

3/8" Compression Faucet Connectors

The following tools are optional:

FlashlightSafety Glasses

Three hole Installation

6"-24" Centerset

Channel Lock

Adjustable Wrench

Pliers

GPM

Flow Rate Chart

PSI

10 20 30 40 50 60 70 80

2.5

1.5

Faucet

Sir

Water supply

Connector

1Installation Guide

Phillips screwdriver

• NSF Certified

• cUPC & UPC

• ADA Approved

• Limited Lifetime Warranty

• Lead Free Construction

1 1/4"

6"-24" Centerset

Summary of content (4 pages)

PAGE 1
Installation Guide Model 706 Wide Spread Lavatory Faucet Certifications & Information • • • • NSF Certified cUPC & UPC ADA Approved Limited Lifetime Warranty • Lead Free Construction GPM Flow Rate Chart 3 2.5 2 1.5 0 0 10 20 30 40 50 60 70 80 PSI Tools Gather the necessary tools as shown to complete the installation of this faucet.
PAGE 2
Installation Guide Faucet Installation A. Turn off the water supply. Remove the faucet and faucet handles with the mounting hardware attached from the package. A B lock nut B. Insert the shank of the faucet handle body into the hole of the sink deck. mounting screws From the underside of the sink or mounting surface, attach the gasket and washer, followed by the lock nut, onto the shank.
PAGE 3
Installation Guide Faucet Installation Continued G. (1) Tighten pop-up stem guide nut. (2) Attach the hot and cold supply lines to the Tee fitting at the faucet base. G (3) Attach the opposite end of each hose to the corresponding quick connect fittings by tightening the 3/8" compression fittings onto the lines. Secure all fittings with a 1/4 turn of a wrench. 3 (4) Secure water line connections to each corresponding faucet handle shank base. Secure all fittings with a 1/4 turn of a wrench.
PAGE 4
www.mrdirectint.com sales@mrdirectint.com 1-877-946-5725 Important Turn on the water supply SLOWLY, to test for leaks before completely opening the water lines. Remove the aerator from the end of the faucet by carefully unscrewing it. Let hot and cold water run through both water lines for at least one minute before replacing the aerator. This will help to clear any debris in the line, which could otherwise clog the system.