Installation Guide

Remove the aerator from the end of the faucet by carefully unscrewing it.
Let hot and cold water run through both water lines for at least one minute before
replacing the aerator. This will help to clear any debris in the line,
which could otherwise clog the system.
Important
Pop-Up Drain Installation
To prevent damage to the tube body, tighten the connections by carefully using two
wrenches as shown. Use caution to not bend the stem.
Check for leaks.
Turn on the water supply SLOWLY, to test for leaks
before completely opening the water lines.
3
Installation Guide
A. Remove pop-up drain stopper (6), and ange (7) with
top rubber washer (8) from the pop-up assembly.
B. Insert drain body (9) from underneath of sink drain hole.
Replace ange (7) and top rubber washer (8) back to
drain body (9). Tighten ange securely.
C. Slide the bottom rubber washer (10) back on the drain
pipe, up to and against the bottom of the sink. Tighten the
washer (11) and the lock nut (12) rmly against the base
to form a tight seal.
D. Replace pop-up drain stopper (6) into the drain body (9)
with o-ring (10) in place, and align the hole in the stopper
with the guide rod opening.
E. Remove the rod guide nut (11) and rod ball rubber
gasket (12).
F. Insert rod ball assembly (13) into the drain body (9)
and through the hole in the drain stopper (14).
G. Replace the rod guide nut (11) and the rod ball
rubber gasket (12) and tighten securely.
H. Insert pop-up stem (15) through the hole in the faucet
body (16). Connect rod ball assembly (13) to the lift rod (18)
using the spring clip (17) to hold and adjust.
I. Attach the lift rod (18) to the pop-up stem (15) by inserting
the stem through the hole in the lift rod (20). Then, adjust the
pop-up stem (15) to the correct height and hand-tighten the
lift rod screw (19).
7
8
11
12
10
6
10
9
15
16
19
18
20
17
13
11
12
14
13
7
9