Sirius Satellite Radio 1221 Avenue of the Americas New York, NY 10020 (800) 869-5590 www.sirius.com SB4000 Boombox User Guide © 2004 Sirius Satellite Radio SB4000-OM (Rev.
FCC Regulations Installation/Wiring Precautions This unit complies with the interference limits relative to a Class B digital device, applicable under Part 15 of the FCC Rules regarding installation in a residential environment. If the unit is not installed in accordance with these instructions, it could cause harmful interference to audio or television reception. If this condition persists after corrective action, consult your dealer or experienced installation facility. Cautions and Warnings 1.
Boombox Controls 3. AUX Jack: Accepts an audio input signal from an external audio device. When using the AUX audio input, turn the Orbiter SR4000 Off to preserve battery power. Adjust the volume level of the external audio device to obtain an audio output from the SB4000. The volume control on the external audio device should be set to a mid-range level. 4. Power On/Low Battery LED: The LED lights green when the Power On/Off Switch- VOL control is rotated clockwise (CW) to the ON Position.
Antenna Mounting Location Antenna Input RF Connector (Antenna) 6 AC Power Adapter Input (DC 12V, 2A) 16-Pin System Connector 5. Installing/Positioning the Antenna: For best reception, the supplied antenna should be placed near a window if in the house or, if outdoors, in an open area and as high as possible; some repositioning may be required to achieve optimum results. The following guidelines are recommended: a.
SB4000 Specifications Periodic Inspection Nominal Output Power per Channel ........................................................................................... 5 Watts RMS Total Harmonic Distortion (THD) .............................................................................................. 0.3% at 1 Watt Frequency Response ............................................................................................................... 30Hz to 20kHz Signal-to-Noise Ratio (S/N) ................
PROBABLE CAUSE FAULT System does not turn on Boombox does not operate using batteries Intermittent Operation “ANTENNA ERROR” Message “ACQUIRING SIGNAL” Message SR4000 Receiver power is set to OFF Turn SR4000 Receiver power on using the Orbiter Power on/off button Batteries not installed or installed incorrectly Install batteries observing correct polarity As long as the AC Power Adapter is attached to the rear panel of the Boombox, battery operation is disabled Remove power connector from rear pane
