User Manual

XM car
antenna
XM
receiver
coupler
clip
coupler
module
XM car
antenna
XM
receiver
coupler
clip
coupler
module
If you have an external or roof mount FM antenna, attach the Coupling Clip
directly to the base of the antenna as illustrated below. Cover the Clip with
the rubber boot provided to protect and secure the clip. Secure the cable
inside the trunk or hood to avoid interference or accidental damage. Install-
ing the Coupling Clip first will avoid having excess cable outside the vehicle.
car
antenna
rubber
boot
c. Slide the boot down the antenna so it covers the clip
coupling
clip
98
External Antenna RoutingOption 1: External Antenna Coupling Clip Installation
In the rear, Always cross the
weather seal at the lowest part of
the trunk to reduce water leaks.
Route the cable into the trunk
through available wire channels.
Route through the rear passenger
compartment. Tuck the cable
under the door jam trim or under
the carpet to the XM Receiver as
shown in figure 3.
In the front, route the cable
across the weather seal near the
bottom of the door to reduce
water leaks. Once inside the car
tuck the FM coupler output cable
into the door jam up to the dash
or under the carpet as shown in
figure 2.
Figure 2
Figure 3
a. Snap the antenna clip into place
b. Slide the boot over the top of your antenna.
(a) (b) (c)
You may want to use the
optional cable wrap for a
more secure solution
Step 2:
Step1 :