User Manual

Note: When routing the FM Coupler cable use pre-existing wire channels whenever possible to
avoid loose wires on the interior of the vehicle which are susceptible to damage and to maintain
a professional looking installation. Route cable carefully by taking notice of how doors open and
close, as well as how seats move when they are adjusted so you can be certain there is ample
clearance provided for the cable.
Avoid inadvertent damage that may be caused by kinking, crimping, twisting or chafing the
cables. Secure and tie wrap the excess cable under your dash board, between the seat and the
console, or on the floor under a seat or floor mat. Securing the excess cable will help to prevent it
from interfering with the everyday use of your vehicle, improve the appearance of the installa-
tion, and avoid any undesirable accidental damage to the cables that might result in loss of
satellite signal or FM Coupler performance.
XM car
antenna
XM
receiver
coupler clip
with contact
bracket
coupler clip
with contact
bracket
internal on glass
antenna
internal on
glass
antenna
coupler
module
XM car
antenna
XM
receiver
coupler
module
14 15
Additional InformationInternal On Glass Antenna Routing
In the rear, route the FM coupler
output cable from the antenna
element, along the window edge,
down to the window liner. From
the rear passenger compartment
tuck the cable und the carpet or
door jam trim up to the front
dash to the XM Receiver. See
figure 5.
In the front, route the FM coupler
output cable from the antenna
element, along the window edge, down
to the window liner along to the floor
up to the dash as shown in figure 4.
Figure 4
Figure 5
Step 2: