User's Manual

Section 5

2. Identify a hard, flat surface within your car to allow the optimum Roady2

viewing position for the primary user as well as access to the cassette

player, power source, and antenna-cable route. In order to maximize

visibility, this position should be chosen to minimize glare or direct

sunlight on the display. Do not install the mount where it or Roady2

could block your vision, vehicle airbags, or controls. Do not install the

mount on a leather surface. The adhesive used on the mount is not easily

repositioned when installed, so please use care when choosing the location

and placing the mount.

3. Clean the vehicle mounting surface with the enclosed surface preparation

cleaning kit. Wipe with the towelette in only one direction. Do not wipe the

surface in a circular motion or back and forth. Dry area with a clean, dry

cloth. Wipe dry in the same direction again and then repeat this cleaning

process. Allow to air dry thoroughly to ensure effective adhesion.

4. Clean the same surface with the enclosed alcohol prep pad. Wipe in the

same direction and manner as with the towelette. Dry the area with a clean,

dry cloth, wiping in one direction. Allow to air dry thoroughly. Ensure that

the surface is at least 60°F.

5. Warm the car mount adhesive pad by using a hair dryer or by placing

the car mount on top of the vehicle’s defrost outlet for several minutes with

the heater on. Remove the liner from the adhesive pad and adhere to the

vehicle’s surface. Make sure you accurately place the pad on the first try

since in many cases it will bond almost immediately. 3M recommends a

72-hour curing time for maximum adhesion.

Note: Your Roady2 Kit includes an optional temporary vent mount that can be used in place

of the more permanent car mount described in steps 2 through 5 above. Follow the same

installation guidelines in selecting a vent. Assemble the mount by inserting the two clips into

the main piece, clip them onto the vent, and then position the pivoting kickstand at the bot-

tom. Be careful when applying and removing the vent mount clips to prevent damaging the

vehicle’s vent.