User's Manual

6. Clip the Roady2 onto the car or
vent mount (figure 6).
7. Reassemble the system as in
step 1, inserting cassette audio
adaptor into the vehicle’s cassette
deck and the 12V power adaptor
into the cigarette lighter.
8. Attach the antenna as explained on
page 22.
Removing car mount from your dashboard
You can remove the car mount from your dashboard by taking the
following steps:
1. Lift one edge of the adhesive pad gently with fingers or the rounded edge
of a spoon. Once enough of the edge is loosened to grip with your fingers,
pull the pad gently from the mounting surface at a 90-degree angle. Avoid
using sharp tools that could damage the vehicle’s interior.
2. If the pad fails to loosen, first warm it with a hair dryer for 2 to 3 minutes
to soften the adhesive. Be careful not to apply too much heat, which could
damage the mounting surface.
3. If any adhesive remains on the dashboard surface, the adhesive can easily
be removed by rubbing your thumb or finger across it.
4. As necessary, use a mild household cleaner to clean the dashboard
surface.
21
Figure 6. Attach car mount to back of
Roady2 as shown.
To vehicle
dashboard
Caution: Never use a commercial heat
gun or paint-stripping gun. This could result in
damage to the unit or to your vehicle.
Section 5