User Manual

Internal OnGlass FM Antenna Contact Bracket Installation

Step 1:

Install the Contact Bracket on the interior window surface over the antenna element

using the adhesive pad provided and the following steps. It may be mounted either

vertical or horizontal depending on the portion of the antenna element most easily

accessed. Select a bracket position that allows room to attach the Coupling Clip and

cleanly run cables without blocking the driver’s view. Install the on-glass antenna

Coupling Clip before routing the cable to avoid excess cable. See Figure 6.

a. Clean the mounting location on the glass for the Contact Bracket with any

household window cleaner that will remove grime. Be sure the surface is com-

pletely dry before proceeding. You may need to use your vehicle’s air conditioning

and/or defogger to keep the cleaned surface dry during the installation for the

adhesive to set properly.

b. Remove the red liner from the adhesive pad and press the Contact Bracket

firmly to the identified mounting location on the glass. You can also view the

alignment through the glass from outside the vehicle. You will have only a limited

amount of time to reposition the Contact Bracket before the adhesive cures.

c. The Contact Bracket has alignment arrows on the side opposite the adhesive pads.

These arrows indicate the contact strip location on the base of the bracket. Align

the arrows with the on-glass antenna element to ensure direct contact between the

strip and the element. Press and hold the Contact Bracket in place for 10 to 15

seconds.

d. Once the Bracket is in place, attach the Coupling Clip to the bracket flange and

route any excess cable behind liners for a professional look.