User's Guide

38
39
You should:
Insert your MyFi into its home
stand and plug the AC adapter
i
nto the wall to charge the battery.
Your MyFi’s battery is low
(see page 12).
Contact XM Satellite Radio.
Your MyFi may not be activated
(
see page 14).
Reduce audio output level
(see page 21).
Increase audio output level
(see page 21).
Check to see if you have plugged
the AC adapter into the home
stand. The audio line output only
works when the AC adapter is
plugged in.
Check that you have not chosen to
skip that channel (see page 26). If
the problem persists, contact XM
Satellite Radio at 1.800.967.2346.
Verify that you are authorized to
receive that channel as part of your
XM subscription, and that you have
not asked XM Satellite Radio to
block that channel.
Nothing is wrong with your MyFi.
That information may be in the
process of being updated. On some
sports and news channels, there is
no title or artist information.
Make sure that the FM radio and
your MyFi are set to the same
frequency (see page 23).
Change to another FM frequency
(see page 23). If the problem persists,
you probably live in an area with
few vacant FM frequencies. You
may want to change to a hard-wired
FM transmitter (see page 29).
Nothing is wrong with your MyFi.
These channels use a different
audio technology than the other
XM channels.
If this happens:
T
here is no power, or your
MyFi shuts off quickly.
You do not receive all XM
c
hannels you have sub-
scribed to.
Audio sounds distorted
when using the built-in FM
transmitter.
Audio is too soft when
using the built-in FM
transmitter.
No audio when using the
home stand that is con-
nected to a stereo system.
You cannot tune to a
channel.
No song title or artist
name displayed.
No audio when listening
through your vehicle’s FM
radio.
Audio has static while
listening through your
vehicle’s FM radio.
Audio on XM Instant
Traffic and Weather
channels sounds different
from other XM channels.
You should:
Check whether the lock indicator
is being displayed. If so, unlock the
c
ontrols by pressing and holding
the “mute/pause/lock” button
u
ntil the lock indicator disappears
(see page 33).
If you have unlocked the controls
and they still do not respond, reset
your MyFi by carefully inserting the
tip of a paper clip into the “RESET”
hole under the battery cover.
You can also reset your MyFi by
removing and reinserting the
battery.
Reset your MyFi by following the
procedure above.
Fully charge the battery, then
use your MyFi until the battery
is fully exhausted. This calibrates
the battery level meter.
If this happens:
Y
our MyFi’s controls do not
respond.
The display does not
change or the backlight
does not turn on or
turn off.
Battery level meter doesn’t
match the charging or
expected playback time.