User's Manual

Onyx EZR User Guide

2. Continue tucking the cable underneath the windshield molding around the windshield to the

lowest corner.

3. At the lowest corner of the windshield, route the cable out of the windshield molding and into the

rubber weather stripping around the door opening. Lift the weather stripping from the opening

and tuck the cable inside it, then replace the weather stripping. Run the cable inside of the

weather stripping to the bottom of the door opening.

4. Pull the cable out of the weather stripping at the bottom of the door opening and route it under

the carpet toward the dashboard. Coil any excess cable in a hidden location, such as under the

carpet, keeping it away from any vehicle pedals or controls. Secure the

excess cable with wire ties.

5. Bring the end of the cable out at the PowerConnect Vehicle Dock

location. Leave yourself enough cable so you can easily connect it to the

antenna connector of the dock.

6. Continue with “Step 5: Connect the Magnetic Mount Antenna and

PowerConnect Power Adapter” on page 18.

Step 5: Connect the Magnetic Mount Antenna and PowerConnect

Power Adapter

1. Plug the Magnetic Mount Antenna into the silver ANT connector on the

PowerConnect Vehicle Dock.

2. Insert the PowerConnect Power Adapter into your vehicle’s cigarette lighter

or power adapter socket.

3. Plug the PowerConnect Power Adapter into the red PWR connector on

the dock.

AUDIOANT PWR FM

AUDIOANT PWRFM

Installation