User's Guide

14
Vehicle Installation
Step 2: Install the Adhesive or Vent Mount
Follow the instructions on the next several pages for the mounting method
you have selected.
Installing the Adhesive Mount:
CAUTION! The adhesive used on the Adhesive Mount may be
difficult to remove. Do not install this mount on leather
surfaces (contact your automobile dealership if you are
unsure about your dash surface), and make sure the air
temperature is at least 60°F (15°C) during installation. If it’s
not at least 60°F, turn on the heater in your vehicle to bring
the temperature up to 60°F.
1. Locate a flat surface for the Adhesive Mount. Make sure there is ample
room for the PowerConnect Vehicle Dock and Onyx Plus Radio when
installed.
2. Set the orientation of the Adhesive Mount before adhering it. Loosen
the knob and adjust the adhesive foot for the location you selected in
“Step 1: Choose a Location for Your Radio” on page 12.
3. The dock mounting plate can be tilted in different directions. Adjust as
necessary for your particular vehicle. When the orientation is correct,
tighten the knob.
Option 1
Option 3
Option 2 Option 4