User's Guide

15
4. Attach the Adhesive Mount to the PowerConnect Vehicle Dock using
the 4 provided screws.
5. Before you attach the Adhesive Mount to the
dash, skip ahead and finish the remainder of
the vehicle installation so that the cables are
attached to the dock.
6. Once the cables have been attached to the
dock, clean the mounting surface in the vehicle
with the alcohol preparation pad and let it dry
thoroughly.
7. Peel off the adhesive liner. Position,
press, and hold the Adhesive Mount in
place for 30 seconds.
IMPORTANT! Allow the Adhesive Mount
adhesive to cure (dry) for a minimum of
2-4 hours before using the mount. The
best adhesion occurs after 24 hours.
TIP! To remove the Adhesive Mount,
carefully lift the adhesive pad with your fingers or a spoon. Warming the pad
with a hair dryer for several minutes will help soften the adhesive.
UDIO
ANT
FM
Vehicle Installation
Knob Adhesive Foot
Dock Mounting Plate