User's Guide

3. Attach the Vent Mount to the

PowerConnect Vehicle Dock using the 4

provided screws.

4. Before you attach the Vent Mount to the

vent, skip ahead and finish the remainder

of the vehicle installation so that the

cables are attached to the dock.

Note! For greater clarity, the next

illustration does not show the dock

attached to the Vent Mount, however, the

dock should be attached before continuing.

5. Once the cables have been attached to the dock, push the Vent Mount

onto the vehicle vent as shown (1) until it hooks on the rear of the vent

louver (2).

6. Rest the foot against the bottom of the vent (2), and adjust the tilt of the

Vent Mount by repositioning the foot to the other adjustment hole (3).

TIP! To remove the Vent Mount, push the mount into the vent. Then lift up

until disengaged from the rear of the vent louver, and remove the Vent

Mount.

Dash

PUSH

Dash

Vent

Louver

Vent

HOOKED

TILT

ADJUSTMENT

HOLES

FOOT

1 2 3

UDIO

ANT

Vehicle Installation