User's Manual
8
MAINTENANCE
* To replace the halogen lamps, remove rst
the glass-blocking ring (Fig. 11A), by leve-
ring with a screw-driver and thus removing
the opaque glass (Fig. 11B) - when perfor-
ming this operation hold the opaque glass
carefully. Remove the lamp (Fig. 11C) without
touching it with uncovered hands. Replace
it with another lamp of the same kind. After
the replacement, re-insert the glass-blocking
ring and fasten it.
To replace the dichroic lamp, remove the
lamp (Fig. 12) by inserting a screwdriver or
another sharp tool between the lamp and its
chrom support and replace it with a lamp of
the same kind.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualied person in order
to avoid a hazard.
* An accurate maintenance guarantees good
functioning and long-lasting performance.
* Particular care is due to the grease lter
panel. It can be removed by pushing its spe-
cial handle toward the back-side of the coo-
ker hood and turning the lter downwards so
to unfasten it from its slot (Fig.3B).
To insert the lter just perform the opposite
operation.
After 30 hours working, the push button
control panel will signal the saturation of
the grease lter by lighting all the buttons.
In the SLTC models (Touch Control Version)
the grease lter saturation is signalled by the
ashing of the two central push buttons (Fig.
14C). Press the timer button to reset .
The grease lter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
There is a re risk if cleaning is not carried
out in accordance with these instructions.
* In case the appliance is used in its ltering
version, the active coal lter (Fig. 10) needs
to be periodically replaced.
The coal lter can be removed by removing
the grease lter rst (Fig. 10B), and by pulling
its special plastic tongue until it is unfaste-
ned from its slot. Re-insert the coal lter by
operating in the opposite way. The coal lter
needs replacing depending on the use, but
however every six months at least.
* To clean the appliance itself tepid water and
neutral detergent are recommended, whi-
le abrasive products should be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated o the product itself to obtain the
desired results).
* Before replacing the lamps, disconnect the
appliance from the electric mains. Remove
the grease lter and the carbon lter, if it is
inserted. Once the burnt out bulb is localized,
turn it anticlockwisely and replace it with a
bulb of the same type.