Owner's Manual

Vehicle Installation
• Sedan/Coupe With the Antenna Placed at the Rear of the Roof:
1. Feed the antenna cable from the antenna underneath the rubber
molding around the rear window.
Use a blunt plastic putty knife or
similar blunt tool
to lift the rubber molding around the rear window
and
tuck the antenna cable underneath the molding. Route the
antenna cable around and down
the window to the lowest point. If
your rear window does
not have rubber molding, we recommend
consulting a professional installer.
2. Route the antenna cable out of
the window molding and into the
rubber weather stripping around
the trunk opening. Lift the weather
stripping from
the opening and tuck the cable inside it, then replace
the weather stripping. To avoid sharp bends in the cable, run the cable
inside
the weather stripping for a few inches, then remove the cable
from the weather stripping inside the
trunk. Keep the cable away
from hinges, gears, etc.,
that could damage it.
3. Route
the cable out
from the rubber weather
stripping and along the
trunk wall. Continue routing
the cable into the vehicle
cabin through a conduit
or along
an existing wiring
harness.
4. Route
the cable through
the main cabin area under
the interior trim, towards