Owner's Manual

Vehicle Installation
• Sedan/Coupe With the Antenna Placed at the Front of the Roof:
1. Feed the antenna cable from the antenna underneath the rubber
molding around the windshield.
Use a blunt plastic putty knife or
similar blunt tool
to lift the rubber molding around the windshield and
tuck the antenna cable underneath the molding. Route the antenna
cable around and down
the windshield to the lowest point.
2. At
the lowest corner of the windshield, route the cable out of the
windshield molding and into the rubber weather stripping around the
door opening.
Lift the weather stripping from the opening and tuck
the cable inside it, then replace the weather stripping.
Run the cable
inside of
the weather stripping to the bottom of the door opening.
3. Pull the cable out of the weather stripping at the bottom of the door
opening and route
it under the carpet toward the dashboard. Coil any
excess cable
in a hidden location, such as under the carpet, keeping
it away from any vehicle pedals or controls. Secure the excess cable
with wire ties.
4. Bring the end of the cable out at the
PowerConnect Vehicle Dock
location. Leave yourself
enough cable
so you can
easily connect it to the
antenna connector of the
dock.
5. Continue with "Step 5:
Connect
the Magnetic Mount
Antenna and PowerConnect
Power
Adapter" on page 39.