Owner's Manual

2. PRECAUTIONS
1. Upon initial startup or when starting
after turning off the backup power
supply, the receiver will take longer to
play audio and may take
up to 30
seconds after reception of the SIRIUS
signal before audio
is heard.
2. Channel names are stored in memory
30 to 60 seconds after start
of normal
operation. If the power
is turned off
before the text data
is written, it may
not be correctly displayed
on the next
power up. Perform a reset operation if
no text data is displayed.
3. If the receiver ever stops functioning or
appears unresponsive, reset it.
• Resetting: Disconnect the SIRIUS
Receiver power cable (the CeNET
cable if connected to the CeNET and
the 4-pin power cable during
standalone operation), wait 10
seconds and connect it again. The last
channel, preset memory and other
data stored
in the receiver are deleted
returning it to its default settings.
4. A CeNET and standalone operation
switch is provided on the underside of
the receiver. The switch
is set to
CeNET position at the time
of
shipment. Do not set this switch to the
standalone position when using the
CeNET cable (headunit operation).
5. The receiver becomes warm during
operation; this is normal and not a
cause for concern.
6. Do not touch the connector pins on the
receiver
as this may damage the ICs
inside the unit.
7. No station is selected when the [adjJ or
[disp] button is pressed quickly after a
channel
is changed. This is because
button operations are not accepted
until the channel
is confirmed. It takes
between 1.5 to 5 seconds to change
channels.
2
This equipment has been tested to comply
with the limits for a Class 8 digital device,
pursuant to Part 15
of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference
in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used
in accordance with the
instructions, may cause harmful
interference to radio communications. '
However, there
is no guarantee that
interference will not occur
in a particUlar
installation.
If this equipment does cause harmful
interference to radio or television reception,
which can
be determined by turning the
equipment off and on, the user
is
encouraged to consult the dealer or an
experienced radio/TV technician for help.
CAUTION
USE OF CONTROLS, ADJUSTMENTS, OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN, MAY
RESULT
IN HAZARDOUS RADIATION
EXPOSURE.
THE COMPACT DISC PLAYER
or
COMMANDER SHOULD NOT BE
ADJUSTED OR REPAIRED BY ANYONE
EXCEPT PROPERLY QUALIFIED SERVICE
TECHNICIANS.
CHANGES OR MODIFICATIONS NOT
EXPRESSLY APPROVED BY THE
MANUFACTURER FOR COMPLIANCE
COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.
INFORMATION FOR USERS:
CHANGES OR MODIFICATIONS TO THIS
PRODUCT NOT APPROVED BY THE
MANUFACTURER WILL VOID THE
WARRANTY AND WILL VIOLATE FCC
APPROVAL.