User guide

3. Attach the Vent Mount to the

PowerConnect Vehicle Dock using the

provided screws.

Note! For greater clarity, the next

illustration does not show the dock

attached to the Vent Mount, however, the

dock should be attached before

continuing.

4. Push the Vent Mount onto the vehicle vent as shown (1) until it hooks

on the rear of the vent louver (2).

5. Rest the foot against the bottom of the vent (2), and adjust the tilt

of the Vent Mount by repositioning the foot to a different adjustment

hole (3).

TIP! To remove the Vent Mount, push the mount into the vent. Then lift up

until disengaged from the rear of the vent louver, and remove the Vent

Mount.

PUSH

Dash

Vent

Louver

Vent

Dash

HOOKED

TILT

ADJUSTMENT

HOLES

FOOT

1 2 3

Vehicle Installation