Owner's Manual

1
Find a Location for Edge and Mount it
Dash Mount Method:
IMPORTANT: The air temperature needs to be at least 60˚ F to install the Dash Mount. If needed, turn on the heater
in your vehicle.
A. Select a flat surface for the Dash Mount with ample room for Edge. Avoid mounting on leather surfaces.
B. Orient the adhesive foot so that Edge is easily accessible. Loosen the knob and adjust the adhesive foot
to position 1 or 2, and then tighten it.
C. Clean the surface with the alcohol preparation pad.
D. Once the surface is dry, remove the adhesive liner. Press
and hold the Dash Mount in place for 30 seconds. Allow the
adhesive cure for 2-4 hours.
E. You can tilt the dock mounting plate in your preferred
direction.
TIP: Choose a location that doesn’t interfere with the driver’s vision or access to driving controls, won’t interfere with
the deployment of airbags or other safety equipment, and makes Edge easily accessible for operation.
1
2
1
Dock Mounting Plate
12
Knob Adhesive Foot
Vent Mount Method:
A. Select a vent with ample room for Edge.
B. Some vents have recessed louvers. If yours are recessed, remove the regular vent clamps and install the
extended vent clamps.
C. Install the Vent Mount onto the vehicle vent:
i. Insert the vent mount into the vent opening.
ii. Push until hooked on the rear of the vent louver. Rest
the foot against the bottom of the vent.
iii. If necessary, adjust the tilt of the Vent Mount by
repositioning the foot to a different tilt adjustment hole.
PUSH
Dash
Vent
Louver
Foot
Vent
Vent
Dash
Dash
HOOKED
TILT
ADJUSTMENT
HOLES
Select either the Dash Mount method or the Vent Mount method for your Edge. Do not attach the PowerConnect Vehicle Dock to the mount. Wait until after you have connected all the cables to the dock.
Start Here