Owner's Manual

2
45
3
6
7
A. Be sure the vehicle is outside and the antenna has a clear view of the sky.
B. Verify that you are receiving the XM signal. The Radio should be tuned to channel 1, the XM Preview channel. There
should at least be one bar on the upper left corner of the screen that denotes antenna signal strength.
C. You can also press menu and then turn the Rotary Knob to scroll to and highlight Signal Indicator. Press the Select
button. The Satellite and Terrestrial bars show the strength of the signal being received. If the signal reception is
good, press and hold menu to return to XM Preview channel 1.
Verify Signal Reception
1
A. Mount the Magnetic Mount Antenna outside your vehicle, on a clean and dry horizontal surface that
will always face the sky.
B. Choose the location for the antenna according to your type of vehicle. Center it between the left and
right sides, and away from other antennas.
C. Install the Cable Routing Adapter to direct the antenna
cable downward, if mounting on an edge.
TIP: Use the Alcohol Prep Pad to clean the surface.
Sedans and Coupes
(above front windshield or rear window)
Pickups
(above front windshield)
SUVs
(rear of roof)
Convertibles
(leading edge of trunk)
Route the Antenna Cable
NOTE: These instructions are for a sedan
or coupe where the antenna is mounted above the front windshield.
The User Guide has detailed antenna cable routing instructions for all
types of vehicles, beginning on page 26.
A. Tuck the antenna cable under the windshield rubber molding
and run it to the nearest corner.
B. Route the cable out of the molding and into the rubber weather
stripping around the door opening.
C. Lift the weather stripping. Tuck and run the cable inside it to
the bottom of the door opening. Replace the weather stripping.
D. Pull the cable out and route it to Edge.
E. Plug the Magnetic Mount Antenna connector into the silver ANT connector at the
rear the PowerConnect Vehicle Dock.
TIP: Include enough slack in your routing to accommodate open doors or the hood lid. Coil
any excess cable in a hidden location and keep it away from any vehicle pedals or controls.
Edge
Location
AUDIO ANT PWR FM
A. Insert the PowerConnect Power Adapter into your vehicle’s
cigarette lighter or power adapter socket. Plug the other end into
the red PWR connector on the rear of the PowerConnect Vehicle
Dock.
B. Use the wire guide on the top of the dock to organize the wires
connected to the dock.
C. Place Edge into the dock and press the Power button.
IMPORTANT! Don’t attach the dock to the mount just yet.
Wire Guide
AUDIO ANT PWR FM
Mount the Magnetic Mount Antenna
Connect the PowerConnect Power Adapter