Owner's Manual

17
necessary for your particular vehicle. When the orientation is correct,
tighten the knob.
4. Attach the Adhesive Mount to the
PowerConnect Vehicle Dock using the 4
provided screws. If you plan to use the wire
guide channel across the back of the Vehicle
Dock to organize the wires, do not fully
tighten the screws. If not, tighten the screws.
5. Once the cables have been attached
to the dock, clean the mounting
surface in the vehicle with the
alcohol preparation pad and let it dry
thoroughly.
6. Peel off the adhesive liner. Position,
press, and hold the Adhesive Mount in
place for 30 seconds.
IMPORTANT! Allow the Adhesive Mount
adhesive to cure (dry) for a minimum of
2-4 hours before using the mount. The best adhesion occurs after 24 hours.
TIP! To remove the Adhesive Mount, carefully lift the adhesive pad with your
fingers or a spoon. Warming the pad with a hair dryer for several minutes will
help soften the adhesive.
Vehicle Installation
Knob Adhesive Foot
Dock Mounting Plate