Owner's Manual

Vehicle Installation

3. Attach the Vent Mount to the

PowerConnect Vehicle Dock using

the 4 provided screws. If you plan to

use the wire guide channel across the

back of the Vehicle Dock to organize

the wires, do not fully tighten the

screws. If not, tighten the screws.

Note! For greater clarity, the next

illustration does not show the dock attached to the Vent Mount, however, the

dock should be attached before continuing.

4. Once the cables have been attached to the dock, push the Vent Mount

onto the vehicle vent as shown (1) until it hooks on the rear of the vent

louver (2).

5. Rest the foot against the bottom of the vent (2), and adjust the tilt of the

Vent Mount by repositioning the foot to the other adjustment hole (3).

TIP! To remove the Vent Mount, push the mount into the vent. Then lift up

until disengaged from the rear of the vent louver, and remove the Vent

Mount.

Dash

PUSH

Dash

Vent

Louver

Vent

HOOKED

TILT

ADJUSTMENT

HOLES

FOOT

1 2 3