Owner's Manual

32
Sedan/Coupe With the Antenna Placed at the Front of the Roof:
1. Feed the antenna cable from the antenna underneath the rubber
molding around the windshield. Use a blunt plastic putty knife or
similar blunt tool to lift the rubber molding around the windshield and
tuck the antenna cable underneath the molding. Route the antenna
cable around and down the windshield to the lowest point.
2. At the lowest corner of the windshield, route the cable out of the
windshield molding and into the rubber weather stripping around the
door opening. Lift the weather stripping from the opening and tuck the
cable inside it, then replace the
weather stripping. Run the cable
inside of the weather stripping
to the bottom of the door
opening.
3. Pull the cable out of the weather
stripping at the bottom of
the door opening and route it
under the carpet toward the
dashboard. Coil any excess
cable in a hidden location, such as under the carpet, keeping it away
from any vehicle pedals or controls. Secure the excess cable with wire
ties.
4. Bring the end of the cable out at the PowerConnect Vehicle Dock
location. Leave yourself enough cable so you can easily connect it to
the antenna connector of the dock.
5. Continue with “Step 6: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter” on page 36.
Vehicle Installation