Owner's Manual

33
SUV:
1. Feed the antenna cable underneath the rubber weather stripping of
the rear tailgate window/door and route the cable along the rear hatch.
Lift the weather stripping from the opening and tuck the cable inside
it, then replace the weather stripping. Pull the cable out from weather
stripping and route it into the cabin under the interior trim. Avoid
hinges or gears that could crimp or cut the cable.
2. Route the cable through the SUV’s main cabin area under the interior
trim, towards the front of the vehicle. Use a blunt plastic putty knife or
similar blunt tool to lift the plastic trim just enough to tuck the cable
under underneath. Avoid side airbag locations on back pillars and
above the doors. Airbag locations are marked with “SRS” logos. Be
careful not to crimp or cut the cable.
3. Bring the cable out from the trim near the front of the cabin and route
it under the carpet toward the dashboard or console. Coil any excess
cable in a hidden location, such as under the carpet, keeping it away
from any vehicle pedals or controls. Secure the excess cable with wire
ties (purchased separately).
4. Bring the end of the cable out at
the PowerConnect Vehicle Dock
location. Leave yourself enough
cable so you can easily connect it
to the antenna connector of the
dock.
5. Continue with “Step 6: Connect
the Magnetic Mount Antenna and
PowerConnect Power Adapter” on
page 36.
Vehicle Installation