User Guide

16
Step 3: Install the Dash or Vent Mount
Follow the instructions on the next several pages for the mounting method
you have selected.
NOTE! The PowerConnect Vehicle Dock included with the this Vehicle Kit is
compatible with the T-slot style Dash and Vent Mounts. If you have an existing
Dash Mount or Vent Mount in your vehicle, you can continue to use it with this
dock, and skip this step.
Installing the Dash Mount:
CAUTION! The adhesive used on the Adhesive Mount may be
difficult to remove. Do not install this mount on leather
surfaces (contact your automobile dealership if you are
unsure about your dash surface), and make sure the air
temperature is at least 60°F (15°C) during installation. If it’s
not at least 60°F, turn on the heater in your vehicle to bring
the temperature up to 60°F.
1. Locate a flat surface for the Adhesive Mount. Make sure there is ample
room for the PowerConnect Vehicle Dock and Radio when installed.
2. Set the orientation of the Adhesive Mount before adhering it. Loosen
the knob and adjust the adhesive foot for the location you selected in
“Step 2: Choose a Location for Your Radio” on page 13.
3. The dock mounting plate can be tilted in different directions. Adjust as
Vehicle Installation
Option 1
Option 3
Option 2 Option 4