User Manual

13
Onyx EZR with Home Kit User Guide
Installation
antenna, turn the antenna slightly to the right or left and observe if the
signal strength increases. For each tweak, allow a few seconds in each
position to determine if the signal strength increases.
If either the Satellite or the Terrestrial signal bar (or both) are more than
half filled, you are receiving a good signal and are done aiming the antenna.
Exit the Signal Indicator screen by pressing and holding menu. If Onyx EZ
is displaying channel 1, the XM Preview channel, with two to three bars of
signal strength displayed at the lower left of the screen, continue with the
next step, otherwise, continue trying other locations for the antenna.
Step 3: Connect the Home Dock to a Stereo System or Powered Speakers
The Home Dock can be connected to your stereo system, or to a set of powered speakers. If you are
connecting to a stereo system, see the following section. If you are connecting to a set of powered
speakers, see “To Connect the Home Dock to Your Powered Speakers” on page 13.
To Connect the Home Dock to Your Stereo System
The Home Dock can be connected to your stereo system through the AUX In or LINE In connection
of your stereo system, using the provided Stereo Audio Cable.
1. Take the provided Stereo Audio Cable and connect the single 1/8” (3.5 mm) connector to the
green AUDIO connector at the rear of the Home Dock.
2. Connect the white left and red right Stereo Audio Cable connectors (“L” and “R” are also on each
respective tip) to any available input other than PHONO on your stereo system. (If your stereo’s
inputs are marked red and black, simply connect the white plug to the black input.)
3. Turn the stereo system On, and make sure you select the correct input on your stereo system for
the AUX In or LINE In connection.
4. If you have connected everything correctly, and you are receiving the XM signal, you should hear
the XM audio from channel 1.
5. The audio level of your Radio can also be adjusted, if necessary. Refer to “Audio Level” on page
36 to adjust the audio level. The installation is complete.
To Connect the Home Dock to Your Powered Speakers
The Home Dock can be connected directly to a set of powered speakers.
1. Connect the 1/8” (3.5 mm) connector from the powered speakers to the green AUDIO
connector at the rear of the Home Dock.
2. Plug the powered speakers into a wall outlet.
3. Turn On the powered speakers.
ANTAUDIO POWER
L
R
1
866-635-2349
siriusxm.com
XM Preview