Instruction Manual

Satellite Radio Superstore | www.SatelliteRadioSuperstore.com | [phone] | [e-mail] | Page 2
Install the Rubber Case Around Controller
Follow the steps below to install the case around the controller.
1
2
Insert the cable into the hole in the
boom le of the case from inside out.
Pull the cable all the way through the hole and
push the controller ush to the end of the case.
Pull the rubber case around the controller.
Prepping the Rubber Case
The rubber case is used to keep out dust and water from the edges of the
Commander Touch™ controller. On the back of the case are four holes used
to mark the locaon of the four screw holes on the back of the controller.
It is recommended to use a small screw driver to push through the case
inside the circles and make a small hole. This will allow the screws to pass
through the case when mounng the case. This step can also be done aer
the case has been installed on the Commander Touch™ controller.
Aaching the Dual Mounng Plate
Locate the Dual Male AMPS Plate from the bag of parts along with the screws. Use a screw driver or other tool to
push a hole through the back of the case in the designated circles marked on the back of the case. Next, take the
Dual Male AMPS Plate and screw it to the back of the rubber case making sure the screw goes all the way through
the case to the screw hole. Be sure to not overghten the screws.
Dual Male AMPS Plate