Instruction Manual

Satellite Radio Superstore | www.SatelliteRadioSuperstore.com | [phone] | [e-mail] | Page 3
Mount Assembly Opons
Before geng started, it is recommended to locate an installaon spot on your UTV that will allow you to see the
screen of the receiver and operate the unit safely while driving. There are three dierent mounng opons included
with this kit. Select the opon that best ts your UTV and installaon requirements.
FLUSH MOUNT
Locate the Dual Female AMPS Plate in the parts bag.
RAM Mount Adapter
Dual Female AMPS Plate
Using four screws or adhesive tape screws mount the Dual Female AMPS
Plate on the dash or other desired locaon.
RAM MOUNT
Locate the RAM Mount Adapter Plate in the parts bag.
Next line up the dual T notches on the back of the controller with the slots
on the Dual Female AMPS Plate and push the controller down. The picture
on the le shows what the plate will look like from the back when the
notches line up with the slots. Be sure to mount the DUAL Female AMPS
Plate to the surface before sliding the display onto the plate.
Using the provided screws aach the
RAM Mount Adapter to the back of the
display. Be sure to press the screws all
the way through the rubber case so
they insert into the screw holes.
ADHESIVE SWIVEL MOUNT
Locate the Adhesive Swivel Mount and the Dual Female AMPS Plate in the bag of parts. Aach the Dual
Female AMPS Plate to the Adhesive Swivel Mount with the provided screws and nuts. Next, slide the display
controller onto the Dual Female AMPS Plate.
Adhesive Swivel Mount
Dual Female AMPS Plate