Instruction Manual

7) SiriusXM Radio Antenna Installaon
Once you have the audio and power connected it's me to install the SiriusXM Radio antenna.
It is recommended to select a locaon on your UTV that will allow the antenna to have maximum clearance from a
roof or other objects.
8) Connecon the Antenna to the Cradle
1. Run the antenna cable from the antenna either inside the roll cage pipe
tubing or along the outside securing the antenna cable with cable es
(not supplied). Be sure not to over ghten the cable es as the stress
could cause damage to the antenna wire.
2. Bring the antenna connecon to the desired locaon (dry box is
recommended) to the SiriusXM receiver. It is recommended to leave a
couple of inches of play in the cable.
3. Connect the antenna wire to the antenna port (ANT) on the docking
cradle.
4. If you need addional cable length to run the antenna you can
purchase SiriusXM antenna extension cables from our website.
9) Power Up and Tune Radio
Aer connecng the antenna, power, and audio to
the receiver docking cradle you will need to tune
the Radio to an empty FM radio channel.
To nd an empty FM channel in your area visit:
hps://www.siriusxm.com/frequency
If there is stac we recommend to select a dierent FM channel.
Satellite Radio Superstore | www.SatelliteRadioSuperstore.com | [phone] | [e-mail] | Page 7
Antenna Installaon Tips
• Magnec Antenna - It is recommended to place the antenna on a
metal surface as high as possible on the vehicle such as the roof or
roll bar. This antenna requires a ground plane for opmal recepon.
• For installing the UTV Post Antenna refer to those instrucons.