Instruction Manual

Install the Power Wiring Harness
The wiring harness has 4 wires: BAT (baery, yellow); ACC (accessory, red); ILL (illuminaon, orange); GND (ground,
black). When installing the harness, keep the fuse holder which is connected to the BAT wire in a locaon that is
accessible in case the fuse ever needs to be replaced.
1. Plug the Wiring Harness connector to the PWR connector on the Tuner Module.
2. Route and connect the BAT yellow wire to a constant 12 volt source, a source which is
always on even when the motorcycle is turned o.
3. Route and connect the ACC red wire to a switched 12 volt source, a source which
provides power only when the vehicle is turned on . This should be ed to the motorcycle’s accessory wire.
4. Route and connect the ILL orange wire to a 12 volt source which is on ONLY when the motorcycle’s exterior
parking or headlights are turned on. DO NOT connect to the Dimmer line as the voltage uctuates. Connecon to
the ILL wire is oponal, but it will allow you to take advantage of the independent Auto Day/Night brightness
seng opon.
5. Route and connect the GND black wire to the motorcycle ground connecon, usually the motorcycle’s chassis.
Install Audio Connecon
There are two ways to connect the audio for the Commander Touch: using the AUX Audio Cable, or using the
FMDA25 FM Direct Adapter. Both audio connecon soluons are included with the Commander Touch and both
audio soluons can be acve at the same me.
• AUX Audio Cable: Best: If your motorcycle’s radio has a auxiliary input jack, this is the easiest way to connect
the audio and provides excellent audio .
• FMDA25 FM Direct Adapter: Good: The FMDA25 FM Direct Adapter directly connects the FM signal from the
Commander Touch to the motorcycle’s radio, reducing any interference which might be present from FM radio
staons. When the Commander Touch is turned o, the motorcycle’s FM antenna is automacally connected
back to the motorcycle’s radio. The FMDA25 FM Direct Adapter connects directly in-line with the motorcycle’s
exisng AM/FM antenna input. Follow the instrucons below for the audio connecon you have selected.
Connecng the Audio Using the AUX Audio Cable
The auxiliary input jack may be located on the face plate of the motorcycle’s radio, on the back of the radio, or
anywhere on the front dash panel.
1. Connect the AUX Audio Cable to the auxiliary input jack of the motorcycle radio.
2. Connect the other end of the AUX Audio Cable to the AUX.
Connector on the Tuner Module.
3. Turn the motorcycle’s radio on, and set it to the AUX In source.
4. Press the Power buon on the Commander Touch Display Controller. Aer the
start up sequence you should hear SiriusXM Preview Channel 1 through your motorcycle’s radio.
Satellite Radio Superstore | www.SatelliteRadioSuperstore.com | [phone] | [e-mail] | Page 9