Owner's Manual
Table Of Contents
- User Guide
- Reset
- Demo Mode
- Table of Contents
- Features
- Supplied Accessories
- Commander Touch Connections
- Install the Commander Touch Display Controller
- Install the Commander Touch Tuner Module
- Install the Magnetic Mount Antenna and Route the Antenna Cable
- Install the Wiring
- Subscribe
- Update the Commander Touch Software
- Using Commander Touch
- Settings
- Troubleshooting
- Specs
11
Commander Touch User Guide
Display Connector
Step 2: Install the Commander Touch Tuner Module
The Commander Touch Tuner Module should be installed and secured behind the dash or center
console using wire ties (not included). Keep in mind that you will need to route several cables to the
Tuner Module, so allow enough clearance for the cable connections.
1. Find a location for the Tuner Module with suitable
clearance for the cable connections.
2. Thread the wire ties through the molded brackets on
the underside of the Tuner Module as shown. Secure
the Tuner Module to a bracket or wiring harness
using the wire ties. Avoid brackets with sharp edges
and any moving parts such as gas, clutch, and brake
pedals.
3. Connect the cable from the Display Controller to the
DISP connection on the Tuner Module.
Introduction